Equipo de recepción y de transmisión

The present document specifies technical requirements, limits and test methods for transceivers and transmitters utilizing Ultra WideBand (UWB) technologies for location tracking for enhanced indoor devices within 6,0 GHz to 8,5 GHz. NOTE: The relationship between the present document and essential requirements of article 3.2 of Directive 2014/53/EU is given in Annex A.

The present document specifies technical requirements, limits and test methods for Millimeter Wave Security Scanners (mmWave SSC, SSC equipment) operating indoor in the band 69,8 GHz to 80,5 GHz. The operating frequency range is split into two bands 97 from 69,8 GHz to 79,9 GHz and 99 from 76,5 GHz to 80,5 GHz as defined in Decision (EU) 2025/105 [i.8]. Details on mmWave SSC equipment and the related categorization is further specified in clause 4.2. NOTE: The relationship between the present document and essential requirements of article 3.2 of Directive 2014/53/EU [i.1] is given in annex A.

This work item implements the extension of the scope of the EN to cover Over the air (OTA) antenna performance requirements in terms of Receiver Total Radiated Sensitivity (TRS) and Total Radiated Power (TRP) for devices over 72mm wide, and will consider essential changes applicable to 3GPP release 13.

The present document specifies technical characteristics and methods of measurements applicable to radio equipment used in MultiPoint (MP) Digital Fixed Radio Systems (DFRS) designed for use in the following sub-ranges (see note 2): • 30 MHz to 1 GHz. • 1 GHz to 3 GHz. • 3 GHz to 11 GHz. • 24,25 GHz to 29,5 GHz. • 31,0 GHz to 33,4 GHz. • 40,5 GHz to 43,5 GHz. NOTE 1: The relationship between the present document and essential requirements of article 3.2 of Directive 2014/53/EU [i.1] is given in Annex A. NOTE 2: For more information on the applicable frequency bands, refer to Annex F. The present document is applicable to multipoint radio system equipment using any arbitrary access method. It applies to all equipment composing the MP systems, i.e. to Central Station (CS), Terminal Station (TS) and Repeater Station (RS). Time Division Duplex (TDD) or Frequency Division Duplex (FDD or H-FDD) can be used on an equivalent basis. Equipment are classified according to one set of Equipment Classification (EqC) (summarized in clause C.4). The EqC set of the equipment under assessment is indicated in the technical documentation (see note 3). Equipment not fitting any of the set of EqC provided by Annex C are not in the scope of the present document. NOTE 3: See definition in clause 3.2. Equipment providing undetachable antennas or providing active antennas (eventually requiring radiated test procedures) are not in the scope of the present document (see note 4). NOTE 4: Rationale is that even if antenna characteristics are not relevant for access to radio spectrum of MP fixed radio systems (see technical description in ETSI TR 101 506 [i.6]), the essential equipment parameters are defined at antenna port and their radiated test procedures are not available. For information, the most common types of antennas are standardized in Part 3 of this multi-part deliverable [i.2]. Systems referring to an EqC with "H" code (see clause C.2.2) as Primary Equipment Classification (PET), implementing an actual FH-CDMA access method with frequency hopping period exceeding 400 ms, are not considered within the scope of the present document. Applications intended for offering in the bands 3,4 GHz to 3,8 GHz the option of Nomadic Wireless Access (NWA), according to the NWA definition in Recommendation ITU-R F.1399 [i.14], are not considered in the scope of the present document.